Generac






Insert screw drier to lock spin shaft from rotate
Remove spin  cup from spin shaft

Remove spin  cup from spin shaft

Spin cup removed away from spin shaft

spin cup removed away from spin shaft

Remove screw driver

Remove screw driver

Removing 5 spacer plates
Notice the side has pins on the spacer plates face down

Removing 5 spacer pplates

Bottom spacer plate removed from spin shaft

bottom spacer plate removed from spin shaft

Last spacer plate and upper cup with spacer inside
removed from spin shaft

Last spacer plate and upper cup with spacer inside removed from spin shaft

Showing spacer and upper cup removed from spin shaft

Showing spacer and upper cup removed from spin shaft

Remove 4 bolts to remove spin shaft spindle component
Replace with 1/4" longer bolts
Come with Awesome Wheel Attachment Plate order

Remove 4 bolts to remove spin shaft spindel component

Inspect parts and components if need to be replaced
Such as
V-belt, clutch cable, springs, finger guards, pulleys

Lift one side of the V-belt off the engine pulley (left side)
Rotate the engine pulley
So V-belt come off from engine pulley groove
No more tension on V-belt

Inspect parts and components

Remove spindle component

Remove spindle component

How V-belt laying with other parts
Remove bolt on pulley to remove and replace V-belt
Inspect parts to see if need to be replace

How V-belt laying with other parts

Install spindle component back o machine

Install spindle component back o machine

Align and lay V-belt on spindle pulley groove
It should be easy as there is no tension on V-belt at this stage

Align and lay V-belt on spindle pulley groove

Install spacer and upper cup back to spin shaft

Install spacer and upper cup akto spin shaft

1st spacer place back on spin shaft
spacer plate side with hole facing up

1st spacer place back on spin shaft

All 5 spacer plates back on spin shaft

All 5 spacer plates back on spin shaft

Pins on last spacer plate face down

Pins on spacer plate face down

Insert screw drive to lock spin shaft from rotate

Install spin cup back on spin shaft turn clockwise
then secure it to spin shaft

Install spin cup back on spin shaft

Remove screw driver

Remove screw driver

Removing screw driver

screw driver remove

install plastic protector guard

Lightly screw the bolt in
just enough so plastic protector guard not falling down

install plastic protector guard

Align the 4 holes on Awesome Wheel Plate
with holes on plastic protector guard

Install Awesome Wheel Attachment Plate
1. Install the other 3 bolts
2. Reach behind Awesome Wheel Plate to remove the 1st bolt
3. Now install this bolt back to the frame
4. Secure these 4 bolts
Remember to use the 4 replacement bolts which 1/4" longer
Longer bolts come with Awesome Wheel Attachment Plate order

Install Awesome Wheel Attachment Plate

Install caster swivel wheel

Install caster swivel wheel

The Generac with Awesome Wheel Attachment Plate installed

The Generac with Awesome Wheel Attachment Plate installed

The Generac with Awesome Wheel Attachment Plate installed
Showing bottom view

Showing bottom view

The Generac with Awesome Wheel Attachment Plate installed
Showing side view

Showing side view


The Generac with Awesome Wheel Attachment Plate installed
Showing front view
You are going to love your trimmer like never before
Thanks to the Awesome Wheel

Showing front view





Your shopping cart is empty!